Instructions
Step by step guide on using Magnee Strapless Knee Pads
MAGNEE Knee Pads attach magnetically to just about any pants material. MAGNEE uses an Inner Cup Pad (B) and Outer Magnet Pad (C) per knee to attach to the pants material. View “A” shows the basic installation of the two pads in a Vertical Attaching. (See below for complete instructions)
|
|
NOTE: There are two (2) ways to attach MAGNEE Knee Pads to your pants. It all depends on the fit and choice of pants you prefer to wear them with. MAGNEE MKP-100 Series can be either Vertically Attached for Regular-Relaxed Fit Pants & Horizontally Attached for Loose Fit-Baggy Pants. MAGNEE MKP-200 Hard Caps Series can only be Vertically Attached for Regular-Relaxed Fit Pants because of the orientation of the Hard Caps.
(See below for complete instructions).
Vertical Attaching - Instructions for Regular Fit Pants
MKP-100 & MKP-200 HD SERIES
STEP 1: Unbuckle waist and slide Inner Cup Pad (B) Vertically down leg inside of pants, cups facing outward. (The soft moisture wicking material
goes against the skin). Position Inner Cup Pad centered on knee (*approx. 6” above the knee and 6” below the knee. See View “A” at top of page).
STEP 2: Sit down, with knee bent feel with your finger the location of the bottom cup under the pant material. Take an Outer Magnet Pad (C) and align
the bottom magnet onto the bottom cup until bottom magnet snaps down and seats securely into bottom cup.
STEP 3: Place the remaining magnet onto the top cup until it snaps down and seats securely into place.
REPEAT STEPS 1-3 FOR OTHER KNEE ATTACHING
SPECIAL NOTE: If the magnets are not seated properly into the receiving cups the pads will fail to work and stay in place causing possible injury.
*Depending on the individuals knee and pants fit it may be necessary to readjust the pads either slightly down or up from center
of the knee to achieve comfort and the correct fit for the magnets to stay seated in the cups.
(Also, “See Trouble Shooting Section Below”)
goes against the skin). Position Inner Cup Pad centered on knee (*approx. 6” above the knee and 6” below the knee. See View “A” at top of page).
STEP 2: Sit down, with knee bent feel with your finger the location of the bottom cup under the pant material. Take an Outer Magnet Pad (C) and align
the bottom magnet onto the bottom cup until bottom magnet snaps down and seats securely into bottom cup.
STEP 3: Place the remaining magnet onto the top cup until it snaps down and seats securely into place.
REPEAT STEPS 1-3 FOR OTHER KNEE ATTACHING
SPECIAL NOTE: If the magnets are not seated properly into the receiving cups the pads will fail to work and stay in place causing possible injury.
*Depending on the individuals knee and pants fit it may be necessary to readjust the pads either slightly down or up from center
of the knee to achieve comfort and the correct fit for the magnets to stay seated in the cups.
(Also, “See Trouble Shooting Section Below”)
Horizontal Attaching - Instructions for Loose Baggy Pants
MKP-100 SERIES ONLY
STEP 1: Unbuckle waist and slide Inner Cup Pad (B) Horizontally down leg inside of pants, cups facing outward. (The soft moisture wicking material
goes against the skin). Center the Top of Inner Cup Pad Horizontally just below the knee cap.*
STEP 2: Sit down, with knee bent feel with your finger the location of a side cup under the pant material. Take an Outer Magnet Pad (C) and align a
Side magnet onto the side cup until the side magnet snaps down securely and seats into the cup, avoid seam of pants.
STEP 3: Stretch pad across knee and place the remaining magnet onto the other side cup until it snaps down securely and seats into place.
REPEAT STEPS 1-3 FOR OTHER KNEE ATTACHING
SPECIAL NOTE: If the magnets are not seated properly into the receiving cups the pads will fail to work and stay in place causing possible injury.
*Depending on the individuals knee and pants fit it may be necessary to readjust the pads either slightly down or up from the
position just below the knee cap area to achieve comfort and the correct fit for the magnets to stay seated in the cups.
(Also, “See Trouble Shooting Section Below”)
goes against the skin). Center the Top of Inner Cup Pad Horizontally just below the knee cap.*
STEP 2: Sit down, with knee bent feel with your finger the location of a side cup under the pant material. Take an Outer Magnet Pad (C) and align a
Side magnet onto the side cup until the side magnet snaps down securely and seats into the cup, avoid seam of pants.
STEP 3: Stretch pad across knee and place the remaining magnet onto the other side cup until it snaps down securely and seats into place.
REPEAT STEPS 1-3 FOR OTHER KNEE ATTACHING
SPECIAL NOTE: If the magnets are not seated properly into the receiving cups the pads will fail to work and stay in place causing possible injury.
*Depending on the individuals knee and pants fit it may be necessary to readjust the pads either slightly down or up from the
position just below the knee cap area to achieve comfort and the correct fit for the magnets to stay seated in the cups.
(Also, “See Trouble Shooting Section Below”)
TROUBLE SHOOTING GUIDE
